Welcome to Nanjing Pengtu Power Supply Co. Ltd.

Malaysia acdc power module potting requirements(2)

2023-06-25

power supply module

Epoxies cannot be used for stress-sensitive and module sealing due to their hardness and are basically eliminated by module power supplies. However, due to its low cost, this epoxy is still used in cost-sensitive micropower supplies. Some domestic bad 48V input power supply manufacturers also use this epoxy resin acdc 48V input power supply module. However, due to stress problems, the failure rate of this 48V input power supply is very high, and buyers are miserable.

At present, the most commonly used power module is the addition of silicone. This kind of silica gel is generally 1:1, which is easy to operate. When acdc potting power modules, attention should be paid to its thermal conductivity. However, the bonding ability is not very strong, and it can be improved with primer.

The secondary power DC/DC converter of the communication power supply has been commercialized. The module adopts high-frequency PWM technology, the switching frequency is about 500kHz, and the power density is 5W~20W/in3. With the development of large-scale integrated circuits, the module power supply is required to be miniaturized, so it is necessary to continuously increase the switching frequency and adopt new circuit topologies. The power density of the module power supply has been greatly improved.

Polyurethane has been used in China for a period of time, but due to its high hardness, inconvenient maintenance, and the price reduction of silicone rubber, the cost performance of polyurethane is not high.