United States of America acdc power module potting requirements(1)

Remote control switch circuit
The remote control switch operation of the module power supply is carried out through the REM terminal. There are two general control methods:
(1) REM is connected to -VIN (reference ground), the remote control is turned off, and VREF<0.4V is required. REM is suspended or connected to +VIN, the module works, and VREM>1V is required.
(2) REM is connected to VIN, the remote control is turned off, and VREM<0.4V is required. REM is connected to +VIN, the module works, VREM>1V is required. REM is suspended, and the remote control is turned off, that is, the so-called "suspended shutdown" (-R).
If the control is to be isolated from the input, an optocoupler can be used to pass the control signal

The potting of the acdc power module is very important. This process not only involves the protection of the power module potting acdc power module (waterproof, moisture-proof, dust-proof, anti-corrosion, etc.), but also involves the protection of the power module. thermal design.

Commonly used power module potting materials are divided into three categories: epoxy resin, polyurethane and silicone rubber

Epoxies cannot be used for stress-sensitive and module sealing due to their hardness and are basically eliminated by module power supplies. However, due to its low cost, this epoxy is still used in cost-sensitive micropower supplies. Some domestic bad Marine boost power supply manufacturers also use this epoxy resin acdc Marine boost power supply module. However, due to stress problems, the failure rate of this Marine boost power supply is very high, and buyers are miserable.